Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 333)

Brocade Mobility RFS7000-GR Controller System Reference Guide 319
53-1001944-01
MU intrusion detection
6
4. Refer to the Violation Parameters field to define threshold values that trigger an alarm:
NOTE
Setting MU threshold values too low can jeopardize MU performance or break the MU’s connection.
NOTE
Setting a violation parameter to 0 will disable that option.
5. When using the Frames with known bad ESSIDs violation parameter it is necessary to enter a
list of known bad ESSIDs for the violation parameter. To enter this information, select Frames
with known bad ESSIDs and then click the Bad Essid Config button to launch a dialogue box
where bad ESSIDs can be added and removed.
NOTE
If using the Frames with known bad ESSIDs violation parameter if no ESSIDs are entered in the Bad
Essid Config dialogue, this parameter will not function.
Violation Type Displays the name of the violation for which threshold values are set in the MU,
radio and switch columns.
Trigger Against (Auth,
Unauth, Ignore) Displays what conditions will trigger the violation parameter against Authorized
APs, Unauthorized APs and Ignored APs. If a violation is triggered by an AP type it
will display with a green check box. If it is not triggered on an AP type it will display
with a red X.
Threshold Values for
Mobile Unit Set the MU threshold value for each violation type. If exceeded, the MU will be
filtered and displayed within the Filtered MUs screen.
Threshold Values for
Radio Set the radio threshold value for each violation type. If exceeded, the radio will be
filtered and displayed within the Filtered Radios screen.
Time to Filter (seconds) Set the Time to Filter interval (in seconds) the switch uses to filter out MUs defined
as committing a violation. Refer to
“Viewing filtered MUs” on page 320 to review
the contents of the MUs that have been filtered thus far.