Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 187)

Brocade Mobility RFS7000-GR Controller System Reference Guide 173
53-1001944-01
Viewing Access Port Information
4
20. Refer to the Status field for the current state of the requests made from applet. This field
displays error messages if something goes wrong in the transaction between the applet and
the switch.
21. If clustering is configured and the Cluster GUI feature is enabled the Apply to Cluster feature
will be available. Click the Apply to Cluster button to apply the AP radio settings to all members
in the cluster.
NOTE
When Cluster GUI is enabled and an Access Port configuration is deleted from one switch, it is not
automatically deleted from other switches in the cluster.
22. Click OK to use the changes to the running configuration and close the dialog.
23. Click Cancel to close the dialog without committing updates to the running configuration.
Configuring rate settings
Use the Rate Settings screen to define a set of basic and supported rates for the target radio. This
allows the radio to sync with networks using varying data rates and allows the radio to default to a
predefined set of data rates when higher data rates cannot be maintained.
To configure Rate Settings for a radio:
1. Click the Rate Settings button within the radio edit screen to launch a new screen with rate
setting information.
2. Check the boxes next to all the Basic Rates you want supported.
Basic Rates are used for management frames, broadcast traffic and multicast frames. If a rate
is selected as a basic rate it is automatically selected as a supported rate.
3. Check the boxes next to all the Supported Rates you want supported.