Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 216)

202 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
Viewing access port adoption defaults
4
- Configure a DNS Server to resolve an existing name into the IP of the switch. The Access Port has
to get DNS server information as part of its DHCP information. The default DNS name requested by
an access point is “Symbol-CAPWAP-Address”. However, since the default name is configurable, it
can be set as a factory default to whatever value is needed.
Editing default access port adoption settings
Use the Edit screen to dedicate a target radio as a detector radio, as well as change the radios
settings (placement, power and channel) and advanced properties (antenna setting, maximum
associations, adoption preference etc.).
To edit radio adoption configuration settings:
1. Select Network Setup > Access Port Adoption Defaults from the main menu tree.
2. Click the Configuration tab.
3. Select a radio from the table.
4. Click the Edit button to display a screen to change the radio adoption default values for the
currently selected radio type (either 802.11a or 802.11bg).