Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 506)

492 Brocade Mobility RFS7000-GR Controller System Reference Guide
53-1001944-01
In this chapter
A
1. Go to Network> Access Port Radios and click on the Global Settings button.
2. Uncheck the Adopt Unconfigured Radios Automatically option to prevent the switch from
automatically adopting new APs when they are connected to the switch.
3. Configure the client bridge back haul WLAN, base bridge and client bridge radios on the switch
using the Command Line Interface (CLI) commands listed below.
Client Bridge Back Haul WLAN Configuration :
RFS7000(config-wireless)#wlan 1 enable
RFS7000(config-wireless)#wlan 1 ssid meshWlan
RFS7000(config-wireless)#wlan 1 independent
RFS7000(config-wireless)#wlan 1 client-bridge-backhaul enable
Base Bridge Radio Configuration: (AP that is wired to the switch)
RFS7000(config-wireless)#radio add 1 “base bridge radio mac” 11bg aap51x1
RFS7000(config-wireless)#radio add 2 “base bridge radio mac” 11a aap51x1
RFS7000(config-wireless)#radio 1 base-bridge enable
RFS7000(config-wireless)#radio 1 bss 1 1
(map the mesh WLAN if manual mapping is enabled, not needed otherwise)
Client Bridge Radios Configuration: (APs that are wirelessly connected)
RFS7000(config-wireless)#radio add 3 “client bridge radio mac” 11bg
aap51x1
RFS7000(config-wireless)#radio add 4 “client bridge radio mac” 11a aap51x1
RFS7000(config-wireless)#radio 3 client-bridge enable
RFS7000(config-wireless)#radio 3 client-bridge ssid meshWlan
RFS7000(config-wireless)#radio 3 bss 1 1
(map the mesh WLAN if manual mapping is enabled, not needed otherwise)
4. Configure Adaptive AP support on the Brocade Mobility 7131N-FGR Access Point by adopting
the APs base bridge as well as client bridge. The client-bridge radios must be wired directly
wired to the switch during this configuration step.
5. Once all APs are adopted, wait for 3 minutes. After 3 minutes disconnect the client-bridge
BBrocade Mobility 7131N-FGR Access Point from the network. The client bridge APs will
continue to be adopted.