Brocade Mobility RFS7000-GR Controller System Reference Guide (Supporting software release 4.1.0.0-040GR and later) - Manual (Page 313)

Brocade Mobility RFS7000-GR Controller System Reference Guide 299
53-1001944-01
Locationing
5
To configure your site parameters:
1. .Select Services > RTLS from the main menu tree.
2. Select the Site tab.
3. Enter a Name and optionally a Description for the site:.
4. When mapping out a site for locationing an origin point must be selected in one of the corners
of the site. That origin will become the upper left corner of the site map with coordinates of
0,0. The length and width of the site is then mapped out on the X and Y axises. Those length
and width along with the height are entered into the field below.
Define the Dimensions and Unit of measure used to define the site size:
Name Enter a name for the site where locationing is deployed. This is for identification
purposes only.
Description Provide a description of the site where locationing is deployed. This is an optional
field.
Length Enter the length of the site. This is the X axis of your site map based on the origin
point of 0,0. The size is either in feet or meters depending on which unit of
measure is selected below. The valid range for length is 1-1000m or 1-9000ft.
Width Enter the width of the site. This is the Y axis of your site map based on the origin
point of 0,0. The size is either in feet or meters depending on which unit of
measure is selected below. The valid range for width is 1-1000m or 1-9000ft.