Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX - Manual (Page 11)

Publication 0160-5.5 - September 1997
P-4 Using This Manual
Safety Precautions (Continued)
DeviceNet Compatibility The 160-DN1 Communication Module is intended for use only with
Bulletin 160 SSC devices. When properly connected, the Communi-
cation Module communicates via the DeviceNet Protocol. The Com-
munication Module/Bulletin 160 SSC combination comprise a
Group 2 Slave Only device. This device supports DeviceNet slave
Polled, Change of State/Cyclic messaging, and DeviceNet slave
Explicit messaging.
!
ATTENTION: The drive contains high voltage
capacitors which take time to discharge after removal
of mains supply. Before installing or removing the
DeviceNet Communication Module, ensure isolation of
mains supply from line inputs [L1, L2, L3 (R, S, T)].
Wait one minute for capacitors to discharge to safe
voltage levels. Failure to do so may result in personal
injury or death.
!
ATTENTION: When a system is configured for the
first time, the motor must be disconnected from the
machine or process during initial system testing. Hazard
of injury or equipment damage may occur due to
unintended or incorrect machine motion.