Installing the communication module, Installing the communication module -6 – Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX User Manual
Page 21
Advertising
Publication 0160-5.5 - September 1997
3-6
Installation and Wiring
Installing the Communication
Module
After setting the DIP switches, secure the Communication Module to
the drive by following these steps:
1. Insert the module, ensuring that the pins on the back of the mod-
ule line up with the drive’s expansion port.
2. Press down on the module until it is fully seated. The module is
fully seated when its sides are resting on the drive’s face.
3. Press down on the latch until it snaps into place.
Figure 3.5
Installing the Communication Module
Expansion Port
Drive’s
Face
Advertising