Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX - Manual (Page 14)

Publication 0160-5.5 - September 1997
Chapter
2
Quick Start for Experienced Users
Objective of This Chapter This chapter can help you start using the Bulletin 160 DeviceNet
Communication module. If you have installed or configured a
DeviceNet network previously and are familiar with Rockwell Auto-
mation DeviceNet modules and drives, this information can help
reduce the time of installation. If you are uncertain, use the full instal-
lation/configuring information beginning in Chapter 3.
We base the procedures here on the assumption that you understand
DeviceNet concepts and know how to program the Bulletin 160 SSC
drive. In addition, you should understand electronic process control
and be able to interpret the ladder logic instructions required to gener-
ate the electronic signals that control your application.
Because it is a start-up guide for experienced users, this chapter does
not contain detailed explanations about the procedures listed. It does,
however, reference other chapters in this book where you can get
more information.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the refer-
enced chapters and other recommended documentation before trying
to apply the information.
This chapter contains the following information:
• What tools and equipment you need.
• When to address, configure and program the module.
• How to install and wire the Communication Module.
• System power-up procedures.
Required Tools and Equipment Have the following tools and equipment ready:
• Small blade screwdriver.
• DeviceNet configuration software or hardware device.