Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX - Manual (Page 43)

Publication 0160-5.5 - September 1997
6-8 Using 160-DN1 with DeviceNet Scanner
Enable Network Control
(Continued) For the new input mode to take effect, P56 - [Reset Functions] must
be modified. Double click on the “reset functions” parameter
P56 - [Reset Functions]. The following screen appears:
Select “Reset Input Mode” and click the “Save to Device” button.
When the save is done, close the window by pressing the “OK” but-
ton.
Configure the 160 to Accept Speed
Commands From the Network The Bulletin 160 must be configured to accept its speed commands
from the network. This is done by changing the “Frequency Select”
parameter. Double click on the P59 - [Frequency Select] parameter.
The following screen appears:
Select “Internal Freq” and click the “Save to Device” button. When
the save is done, close the window by pressing the “OK” button.
➊
➌
➋
➊
➌
➋