Enable network control, Enable network control -7 – Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX User Manual
Page 42
Advertising
Publication 0160-5.5 - September 1997
Using 160-DN1 with DeviceNet Scanner
6-7
Enable Network Control
The Bulletin 160 must be configured to accept commands from the
network. This is done by configuring the “Input Mode” parameter. To
do this, select the “Program” parameter group as shown below:
Double click on the “Input Mode” parameter (number 46). The fol-
lowing screen appears:
Select “Network Control” and click the “Save to Device” button.
When the save is done, close the window by pressing the “OK” but-
ton.
➊
➌
➋
!
ATTENTION: Changing this parameter value may
cause unpredictable network conditions, resulting in
equipment damage, personal injury, or death. Ensure
that you understand how changing this parameter
affects your application.
Advertising