Rockwell Automation 160 DEVICENET (DN1) MODULE FRN 1-2.XX - Manual (Page 92)

Publication 0160-5.5 - September 1997
Appendix
C
ODVA Interface Parameter Descriptions
The ODVA Interface This appendix describes in detail the parameters that are defined in
the ODVA Interface EDS files contained on the 160-EDS disk (Cat.
No. 160-EDS).
Important: This document describes the parameter set for a Series B
Bulletin 160. If using a Series A Bulletin 160, then not all the param-
eters listed in this manual may apply to that device. When using a
Series A Bulletin 160 please refer to the Bulletin 160 SSC User
Manual (publication 0160-5.0).
ODVA Drive Profile Interface When P15- [Interface Select] has a value of 1, the ODVA Drive Pro-
file Interface is selected. This interface contains standard parameters
that are defined in the ODVA (Open DeviceNet Vendors Association)
Drive Profile, plus some extra parameters to configure the operation
of the Communication Module on the DeviceNet network, and to con-
figure some features of the 160 SSC drive that are not included in the
ODVA Drive Profile. This interface differs from the Bulletin 160 SSC
Interface in many aspects. For example, speeds are defined in RPM
rather than Hz. This interface is included to give the Bulletin 160 SSC
drive true interoperability with other DeviceNet equipped drives that
adhere to the ODVA Drive Profile.
ODVA Drive Profile Interface Param-
eters When this interface is selected, parameters are logically grouped
together as follows:
• Motor Group.
• Control Supervisor Group.
• Interface Select Group.
• AC Drive Group.
• AC Drive Extensions Group.
• DeviceNet Configuration Group.
• Preset Group (Preset Speed drives only).
The following table summarizes the ODVA Drive Profile parameter
set.