Interlogix VEREX Director - Manual (Page 103)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 95
Screen Reference
- Area (bottom of form): This is
where you select an area to
view its status or control items.
This shows a reference number
assigned by the system, plus
the name/description of the
area as defined under
'Configuration'.
- [Off] , [Stay] , and [On]: These
buttons indicate the present
arming-level of the area, and
allow arming/disarming an area as desired (if
you have this authority). Note: If an item is in
'alarm' or 'trouble', this should be corrected
before you proceed. (The system will typically
prompt you to deal with the situation).
- Fire / Alarm: Whether or not any fire-type inputs
and/or other inputs in the area have been
'tripped'.
[Silence]: This allows silencing alarms that are in
effect as desired—if you have this authority.
- Ready, etc.: Various misc. status aspects for
the specific area (if the area is ready to be
armed, or if doors are open, etc.).
- Schedule-Related Items (visible only for a
scheduled area) : This shows schedule-related
status topics, and provides buttons to set/delay
the closing time
[Work Late] , or [Suspend] (or
Resume) the schedule (if you have the
authority).
- Door Reader Commands for all Doors of the
Area (3 buttons across the middle): Allows
controlling all doors in the selected area (if you
have the authority).
[Lock All Doors]: This locks / re-locks all doors
pertaining to the selected area (i.e., all doors with one
of its readers set to this area);
[Unlock All Doors]: This unlocks all doors pertaining
to the selected area (i.e., all doors with one of its
readers set to this area);
[Advanced]: This button provides access to
additional reader/door commands. Selections include
unlock/relock the doors, lockout or reinstate card
access, and/or change various modes at the doors.
"Momentary" pertains to the defined "Unlock Duration"
(such as when a person uses their access card), and
"Pending" means the command will be held until after
one valid user gains entry at the door.
Reader commands pertain to all readers that allow
entering (or remaining within) the specific area.
Readers that allow exiting from the area will be set to
either a different area, or "outside".
For details on the various reader modes, card modes,
and class map settings, refer to "Doors, Readers, and
Related Settings".
Elevator Readers: These commands do not apply to
readers in elevator (lift) cabs. To control an elevator
and/or its associated reader, refer to "Checking Status
or Controlling Elevators".
- Door List: Shows the status of doors in the
area, and provides selections for unlocking or
relocking individual doors (if you have the
authority).
Pending Unlock: This is an "unlock" that waits until
someone gains entry at the specific door.
- Input Point List: Shows the status of input
points (sensors) in the area, and allows
bypassing individual sensors in each area (for
points that support this, and if you have the
authority).
The Door-List and Input-Point List are available only in
'forms' view (click Form on the toolbar to switch to
'forms' view).
Control & Status Panel Control & Status Areas