Interlogix VEREX Director - Manual (Page 297)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 289
Detect Duplicate Cards allows installers to choose if they would like to detect duplicate cards with an
account only or across all accounts in the Community Group. A new column has been added to the
Community Groups screen to allow the installer to choose the mode of operation.
When the Community is configured for detection “Within Each Account Only” then duplicate cards
will only be detected at the account level. This means that card ids may be duplicated within other
accounts within the Community, only duplicate card ids within an account will be detected. When
the Community is configured for detection “Across All Accounts in this Community” then duplicate
card ids will not be allowed amongst any of the accounts in the Community.
The default when creating a Community is ”Across All Accounts in this Community”. When
performing an installation upgrade to V4.79, the conversion utility will detect if there are any
duplicate card ids. If there are duplicates then the setting will be “Within Each Account Only” else it
will be set to the default of “Across All Accounts in this Community”.
The example: to setup the new options in the Director (≥V4.80)
Create Two Communities:
Add Community Group “Detect Across All Accounts” with “Across All Accounts In This Community”
selected.
Add Community Group “Detect Within Each AccountOnly” with “Within Each Account Only” selected.
Detect Duplicate Cards