Interlogix VEREX Director - Manual (Page 347)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 339
You can Customize Your MyTools Bar
The MyTools bar/list can be customized as
desired. The MyTools settings are saved
separately for each operator, allowing
everyone to use their preferred layout.
Tip: The contents of your MyTools bar (i.e., for the
present operator) are saved automatically when you
change any settings through this screen.
Opening and Positioning the MyTools
Bar
To open or close the MyTools bar, click
[MyTools] on the toolbar. To change its
position, click-and-drag the top or left edge of
the bar to a new location.
You'll typically use the MyTools bar, or the Tree, but
not have both of them open at the same time.
Notice: If no items are set to appear on the MyTools
bar, it will appear as a small empty button (right-click it
to access this screen).
To save the position of your MyTools bar (along with
other desktop changes) open the View menu, select
Desktop Settings, and Save. (You will also be asked
if you want changes saved when you logout or exit.)
Changing the Look or Content of Your
MyTools Bar
Tip: If you are doing this for someone else, be sure to
login as that operator.
To access the "Customize MyTools" screen,
open the
View menu, select MyTools , and
then Customize . (You can also right-click the
double-line at the starting-edge of the MyTools bar, and
select Customize.)
Adding Items: Select the desired item(s)
under "Available Buttons" and click
[Add] .
(Alternatively, you can drag-and-drop items into
position.)
Tip: Use the "Separator" to visually separate blocks of
items on your MyTools bar.
Removing Items: Select the desired item(s)
under "Current MyTools Buttons" and click
[Remove] . (You can also click-and-drag items out of
the list.)
Changing Item-Positions: Select the desired
item(s) under "Current MyTools Buttons", and
click on the 'hand' pointing up or down as
necessary.
You can also 'drag' items to a new
position (release items just above the desired position).
Changing Item-Names: Click twice slowly
on the item-name in the "Current MyTools
Buttons” list, and edit the name as desired.
When finished, press the
[Enter] key (or click
elsewhere on the form).
-------------------------
For more information, refer to the selection-
descriptions for this screen. When finished
click
OK to save your settings.
If you wish to leave your workstation: Click [OK] before
you leave, and make any additional changes when you
return.
Customizing the MyTools Bar