Interlogix VEREX Director - Manual (Page 270)

262 Verex Director V4.9.1 User's Guide 21-0381E v4.9.1
If you change the name or other setting for a floor, this
will cause that floor to be reset to its default / scheduled
state (this allows configuration updates to be managed
properly). To check or re-set the floor state (secure vs.
desecure), refer to the "Floor" status/control topic.
Access-Controlled Floors
Systems with elevator controllers can include
up to 124 access-controlled floors. These can
be in a single building, or the total number of
floors between multiple buildings.
Each system supports up to 32 elevator cabs (max. 32
doors plus elevators in total). To set up an elevator and
its associated reader, refer to "Elevators (Lifts) and
Associated Readers".
Panel/Firmware Revision: Support for elevators and
controlled floor-access requires V3.0 panel firmware.
Recommended:
 V3.2 panel firmware, and  V1.5
elevator controller firmware.
Feature-Set and Licensing: Support for elevators and
floors requires a 'feature-set' selection of 5 or higher
(via Enterprise software licensing).
For details, refer to "Account-Wide Panel Settings", and
"Software Activation and Licensing".
Wiring: Elevator controller floor selection relays must
be wired to the floor call buttons in the same relative
order for all elevator (lift) cabs (such as from lowest to
highest accessed). The floors must then be entered
here in the same order overall (such as from lowest to
highest). For an elevator setting that also affects floor
relay wiring, look for the "Relay Off When Desecure"
setting under "Elevators (Lifts) and Associated
Readers".
How to Get Here
Multi-Account Systems: First select [Account Folders]
in the 'tree', and locate and double-click the desired
account.
MyTools Bar: Floors
In the Tree: YourAccount, Floors
.
Note: This screen uses a custom grid view. (Forms
view does not apply here.)
Things You Can Do
 Add a Floor: Click within the name field for
a blank/grey floor-row in the table, and enter
your desired name.
Attention: Floors must be entered in the same
relative order as per the floor-selection relay wiring
for all elevators (such as from lowest to highest).
 View/Change an Existing One: Scan the
list to view or change settings as desired.
 Delete a Floor: Right-click the item in the
list, and select "Delete". When prompted to
confirm, select Yes.
Before Deleting: Only unused floors can be deleted.
(Issue reports, OR go to the screens for Elevators,
user authorities, and suite-security keypads,
select grid view, and check for the specific floor.)
Related Topic(s):
 Reporting on Users, System/Device Settings, etc.;
 Working with the Report Viewer
Floors (Pertaining to Access-Controlled Elevators / Lifts)