Interlogix VEREX Director - Manual (Page 315)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 307
If you HAVE Access to the
Internet on This PC
 After entering the Registration
Information and Internet Access is
available on the Director host PC,
select:
and press the “Next” button.
 The License Manager will connect
with the Licensing Server over the PC’s Internet connection, to register the key. After a few minutes, a
message should appear that the procedure was successful and your validation Key value will be
automatically changed.
 Press the “Done” button at the bottom of this screen.
 The Information screen will display again with the Key Type Feature Value listed as “Registered”
 You can now exit License Mgr. and the
Director program will be fully functional.
If you Have Access to the Internet
from a Different PC Only
 Select:
and then the “Next” button.
 A message will appear with instructions for connecting to the Internet Server at another PC that does
have Internet Access.
 If there is a printer connected to the Director host PC, press the “Print…” button at the bottom of the
Dealer Information screen.
 The key value and Dealer Info will print out or, if no printer is available, write the information down.
 Take this information and the Director version 4 installation CD to a computer that does have Internet
access.
 Run the CD and run the “Secure License Agent” from the CD’s directory.
 Select the “Register” button and enter the key value and Dealer Info. in this Registration screen. Press
the “Next” button.
 The License Agent will connect with the Licensing Server over this PC’s Internet connection and if
successful, a new validation key value should display where the old one was. Record this new key
value. Close the Secure License Agent and remove the Director installation CD.
 Take the new key value back to the host Director PC running the License Mgr. and enter the new key
value in place of the old one in the Register screen. Press “Next”. A success message should appear.
Press “Done” and the Information screen will display the Feature Key Type Value as “Registered”.
 Close the License Manager and the Director program is now fully functional.