Interlogix VEREX Director - Manual (Page 55)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 47
Screen Reference
- Monitor Tour (bottom of form): This is
where you select an active guard tour
to view its progress/status. This area
shows the name of the guard tour (as
defined under "Guard Tour");
- General: This area shows the 'tour'
being monitored, plus the name of the
guard (user), and the defined action to
occur if the guard is late or absent at
any of the stations (checkpoints).
- Station Status: This area lists the
stations (checkpoints) in the selected
tour being monitored, plus the status,
elapsed time, and other items for each
checkpoint;
Not Initialized: A status of 'Not Initialized' refers to a
guard-tour station that occurs later in the tour (i.e.,
after the next / pending station).
Area Arm/Disarm Commands: These trigger
automatically when the guard accesses the preceding
station within the allowed time.
Tip: To view additional items, you can use the scroll-
bar at the bottom of the window.
Grid View: In Grid view, you will see a list of all active
guard-tours, showing the tour names, guard (user)
names, present status, and the present (last) station
accessed. Selections are also provided to Stop the
monitoring of an active tour, or Start (activate) a tour.
- Guard Tour: This is where you select
a (previously defined) guard tour to
begin monitoring;
- Start Point: This allows starting the
tour at any station / checkpoint (select
the station that the guard will begin
with).
Notes: For the station selected as the
'Starting Point', the min/max times are
relative to the tour activation time (i.e.,
when you click OK).
A guard tour cycles through the defined
'stations' (checkpoints) and then stops (it
does not automatically restart at the
beginning).
- User: This is the "user" (i.e., the
guard) to be performing the guard tour.
Control & Status Guard Tour Monitor
Right-click screen, and select "Start Tour" (Add New)