Interlogix VEREX Director - Manual (Page 41)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 33
The Report Viewer
When a report is set to be
viewed, it appears with a
toolbar allowing:
 Viewing different pages of the
report;
 Setting the portion of each
page that will be visible at one
time (zooming in or out);
 Selecting a printer, and/or
setting the pages to be
printed;
 Printing the report.
Setting the Size / Visible
Portion
of a Report
To change the size/visible
portion of a report:
 Select one of the pre-set
magnification levels (page
symbols), or;
 Enter a desired magnification in the "%" box,
and press Enter .
Viewing Different Pages
To view a different page:
 Use the 'browse' buttons to find a page
(typical), or;
 Enter a desired page-number into the
'current page' box.
Printing a Report
To print the report that is presently on-screen,
click the print button (printer symbol). When
the next screen appears, select your desired
page-range, etc., and click
OK . Tip: To select
a different printer click Printer , and make your
selection from the 'Print Setup' screen that
appears.
VEREX Director automatically sets the preferred page
orientation for each report (portrait or landscape). This
setting should be left as-is.
Closing a Displayed Report and
Returning to the Main Screen
To close the report viewer window, and return
to the main desktop, click
[Close] on the
report-viewer toolbar, or click the ' X ' in the top-
right corner of the report viewer window.
Screen Reference
(Report Viewer Toolbar)
- Print (printer symbol): This allows selecting
and/or setting up a printer, and printing either
the whole report, or a specific range of pages.
- Pre-set Magnifications (page symbols):
These selections allow viewing an entire page at
a time, or the page width, or viewing each page
actual-size (100% magnification);
- Zoom (xx%): This area shows the present
magnification level for the displayed report, and
allows entering a different value.
- |< < > >| (browse buttons): These buttons
allow moving to the first, previous, next, or last
page respectively.
- Current Page (xx): This area shows the page
number that is presently displayed, and allows
jumping to a different page by entering the page
number directly.
- [Close]: This closes the report viewer, returning
you to the VEREX Director desktop. (This is the
same as clicking the
X in the top-right corner of
the screen.)
Working with the Report Viewer
When Viewing a Report