Interlogix VEREX Director - Manual (Page 153)

21-0381E v4.9.1 Welcome Report Control Admin Sys Config Tech-Ref 145
Details: Right-click the 1 st
one (a blank area above
the 'tabs' in 'Forms' view),
and select Copy. Then,
select a blank/new
authority from the list (or
other desired authority),
right-click near the top as
before, and select Paste.
After 'pasting', change the
name and any settings as
desired.
Screen
Reference
Pick-List (bottom
of the Form)
- Authority: This is where you select a user-
authority to view or edit. This area shows a
reference number assigned by the system, and
the name of the selected authority, once
defined;
Top of the Form
- Name: A suitable name or description for the
authority (e.g., Managers);
- Accept Duress PIN: If the Account Information
-> Setup -> Allow PIN Duress checkbox is
checked, the global PIN Duress functionality is
on. By using the “Accept Duress PIN” checkbox
it is possible to allow/deny the functionality for
certain Authorities. If the global duress
functionality is disabled, the “Accept Duress
PIN” checkbox is grayed out.
 Area Attributes 
Area Selection Window on the Left
- Right-click within the Area-selection
Window: Right-clicking within the area window
allows selecting:
+ Physical View (): Areas listed on a panel-by-
panel basis;
+ Physical View (NOT selected): All areas shown in
a single list;
+ View Panel Information: When NOT in "Physical
View", this allows showing or hiding the panel group
and panel name for each area in the list.
+ Remove Area: When you right-click a specific area
in the list, selecting "Remove Area" removes all
authority selections for that area, thereby removing
that area from present consideration within your
present user-authority.
- Small "+/-" symbol in Physical View: Click
this to show or hide the areas for each panel.
- Tiny 1 st Column (far left): Look carefully at the
top of the area selection window, and you'll see
a tiny first column on the left. This allows
selecting multiple areas, so you can then make
selections for groups of areas at the same time.
Caution: This also copies present settings (if any)
from your presently selected area(s) into each
additional area you select. Exception: If the newly-
selected area already contains selections, you will be
prompted to confirm (or abort) the operation.
Similarly, changes may be applied automatically to
other areas with the same authority selections—with
or without an optional confirmation prompt on the first
edit—which is selectable for each operator.
This prompting can be turned off if desired.
Related: [Management, Operator, Operator

Operators (People Who Can Use This Software).
To 'Unselect' an Area: To clear all authority selections
for an area selected accidentally, right-click the area,
and select "Remove Area" from the pop-up menu.
- 2 nd column ("Area Select"): Selecting an area
within the column that includes the area name
allows selecting one area at a time to view or
edit. For any other areas that presently have
the same settings, you'll see a small "=" in the
first column.
Tip: This also provides a way to 'shift focus' from one
block of areas to another (i.e., select the first one for
the new grouping here, and then go back to the small
1
st column to select the rest of the desired areas).
Authorities (for users)