Interlogix VEREX Director - Manual (Page 368)

360 Verex Director V4.9.1 User's Guide 21-0381E v4.9.1
Table 2: Arming station Tones
Condition Standard Tones Reverse Tones
Fire 3 times 500 ms on and off, then
there 1 second gap 3 times 500 ms on and off, then
there 1 second gap
Chime Double short :
125 ms on and 125 off four times
Double short :
125 ms on and 125 off four times
Exit/Entry Delay Slow cadence: slow on/off tones
On Time: 250 ms
Off Time:750 ms Steady continuous tone
Exit Delay with point open
(see note below) Fast cadence: fast on/off tones
On Time: 250 ms
Off Time: 250 ms Fast cadence: fast on/off tones
On Time: 250 ms
Off Time: 250 ms
Confirm Exit delay Fast cadence: fast on/off tones:
On Time: 250 ms
Off Time: 250 ms Fast cadence: fast on/off tones:
On Time: 250 ms
Off Time: 250 ms
Trouble – Alarm,
Area Fail to Arm
(see note below) Steady continuous tone Slow cadence: slow tune on/off
tones:
On Time: 250 ms
Off Time:750 ms
Entry delay with
was/current in alarm Fast cadence: fast on/off tones
On Time: 250 ms
Off Time: 250 ms Fast cadence: fast on/off tones
On Time: 250 ms
Off Time: 250 ms
Area closing – 15 minutes Double short tones:
125 ms on and 125 off four times.
Tones faster during last 5 minutes Double short tones:
125 ms on and 125 off four times.
Tones faster during last 5 minute
Note: For conditions referencing this note, the tone will NOT be generated if the applicable area’s “Fail to Exit Mode” is
set to None/0 (zero).
Table 3: Buzzer via Output set to Follow Sonalert
Output Ref: Configuration, Output Points, […], ”Area, Area x, Sonalert…”)
Condition Standard Tones Reverse Tones
Fire 2 seconds on/off. 2 seconds on/off
Chime 1 second on 1 second on
Exit/Entry Delay 1 second on two second off Steady continuous tone
Exit Delay with point open
(see note below) 1 second on/off 1 second on/off
Confirm Exit delay 1 second on/off: 1 second on/off
Trouble – Alarm,
Area Fail to Arm
(see note below) Steady continuous tone 1 second on two second off
Entry delay with
was/current in alarm 1 second on/off: 1 second on/off
Area closing – 15 minutes 1 second on.
Tones faster during last 5 minutes 1 second on.
Tones faster during last 5 minutes
Note: For conditions referencing this note, the tone will NOT be generated if the applicable area’s “Fail to Exit Mode” is
set to None/0 (zero).