Maxim Integrated High-Speed Microcontroller Users Guide: Network Microcontroller Supplement User Manual
Page 202
High-Speed Microcontroller User’s
Guide: Network Microcontroller
Supplement
202
getipv6params
Descriptions:
getipv6params(
void *parameters);
/* pointer to IPv6 parameters buffer */
The
getipv6params function returns the IPv6 address of the Ethernet interface to the parameters buffer. The parameters buffer
contain the following data following the
getipv6params function:
PARAMETER
OFFSET
LENGTH
DESCRIPTION
IP6ADDR 0
16
IP
address
IP6PREFIX
16
1
IP prefix length
getethernetstatus
Description:
int getethernetstatus(void);
The
getethernetstatus function returns the Ethernet status (link). The return value is a bit-wise OR of the following flags:
FLAG*
VALUE
DESCRIPTION
ETH_STATUS_LNK
01h
Ethernet link status
*(No other flags are currently defined.)
gettftpserver/settftpserver
Descriptions:
int gettftpserver(
struct sockaddr *addr,
/* address of TFTP server */
int *addrlen);
/* length of addr structure */
int settftpserver(
struct sockaddr *addr,
/* address of TFTP server */
int *addrlen);
/* length of addr structure */
The
gettftpserver and settftpserver functions get/set the IP address of the TFTP server. The gettftpserver function stores the
address of the TFTP server into the addr structure. The
settftpserver function sets the TFTP server address to the value sup-
plied in addr. The
settftpserver function must be used if the address of the TFTP server is not acquired by DHCP or 1-Wire.
Both functions return a success/failure code in the accumulator.
INPUT
PARAMETER#–DESCRIPTION
OUTPUT
DESCRIPTION
*addr
addrlen
Param0[0:2]–Pointer to addr
Param1[0]–Size of addr structure
ACC
Return value (= 0 for success)
INPUT
PARAMETER#–DESCRIPTION
OUTPUT
DESCRIPTION
—
ACC
R0
Return value (= 0 for success)
Return value (bit-wise OR of flags)
INPUT
PARAMETER#–DESCRIPTION
OUTPUT
DESCRIPTION
*parameters
Param0[0:2]–Pointer to
parameters buffer
ACC
Return value (= 0 for success)
Maxim Integrated