Pilz PSSnet SHL 8T MRP - Manual (Page 156)

Operation diagnosis
PSSnet SHL - Basic Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
9.2 Monitoring the device status
157
9.2 Monitoring the device status
The device status provides an overview of the overall condition of the device.
Many process visualization systems record the device status for a device in
order to present its condition in graphic form.
The device enables you to
X signal the device status out-of-band via a signal contact
(see on page 161 „Monitoring the device status via the signal contact“)
X signal the device status by sending a trap when the device status changes
X detect the device status in the Web-based interface on the system side.
X query the device status in the Command Line Interface.
The device status of the device includes:
X Incorrect supply voltage,
the failure of at least one of the two supply voltages,
a permanent fault in the device (internal supply voltage).
X The temperature threshold has been exceeded or has not been reached.
X The removal of a module (for modular devices).
X The removal of the SCA.
X The interruption of the connection at at least one port. In the Basic Set-
tings:Port Configuration menu, you define which ports the device
signals if the connection is down (see on page 72 „Displaying connection
error messages“) . On delivery, there is no link monitoring.
X Event in the ring redundancy:
Failure of the redundancy (in ring manager mode). On delivery, there is
no ring redundancy monitoring.
X Event in the ring/network coupling:
Failure of the redundancy. On delivery, there is no ring redundancy
monitoring.
The following conditions are also reported by the device in standby mode:
– Defective link status of the control line
– Partner device is in standby mode
Select the corresponding entries to decide which events the device status
includes.