Pilz PSSnet SHL 8T MRP User Manual
Page 56
Loading/saving settings
PSSnet SHL - Basic Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
3.1 Loading settings
57
Note: The loading process started by DHCP/BOOTP
(see on page
41
„Sys-
tem configuration via BOOTP“)
shows the selection of "from URL & save
locally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.
Figure 17: Load/store dialog
enable
Switch to the Privileged EXEC mode.
copy tftp://149.218.112.159/
switch/config.dat
nvram:startup-config
The device loads the configuration data from a
tftp server in the connected network.