Web-based ip configuration, 8 web-based ip configuration – Pilz PSSnet SHL 8T MRP User Manual
Page 49
Entering the IP Parameters
50
2.8 Web-based IP configuration
PSSnet SHL - Basic Configuration
Pilz GmbH & Co. KG, Felix- Wankel Str. 2, 73760 Ostfildern
2.8 Web-based IP configuration
With the Basic Settings:Network dialog you define the source from
which the device gets its IP parameters after starting, and you assign the IP
parameters and VLAN ID and configure the HiDiscovery access.
Figure 16: Network parameters dialog
Under "Mode", enter where the device is to obtain its IP parameters:
X
In the BOOTP mode, the configuration is via a BOOTP or DHCP serv-
er on the basis of the MAC address of the device
(see page
180)
.
X
In the DHCP mode, the configuration is via a DHCP server on the ba-
sis of the MAC address or the name of the device
(see page
186)
.
X
In the local mode the net parameters in the device memory are used.
Enter the parameters on the right according to the selected mode.
You enter the name applicable to the DHCP protocol in the "Name" line in
the system dialog of the Web-based interface.