Enterasys Networks X-Pedition XSR CLI - Manual (Page 150)

Hardware Controller Clear and Show Commands
4-98 Configuring Hardware Controllers
Packet Processor Tx Scheduler Stats:
0 Packet driver Tx OK
0 Packet driver not Tx: MUX END_ERR_BLOCK
0 Packet driver not Tx: MUX ERROR
0 Packet driver not Tx: Unknown Msg from MUX
The unit number is 50331656.
The interrupt number is 26.
The DSR poll count is 800 ms.
The ACCM is at 0x01040acc.
Vars: CCR2=0x98ff0500, CCR1=0x98ff0500, CCR0=0x00000000, CD=0, g_Ser=0
Vars: bHandleRx=0, bTxClean=0
Vital Stats: TX Q Items = 0, TX Q Bytes = 0, TX CLK = 0
Memory: base = 0xa0020000
TX RING ENTRIES:
The interrupt ring starts at 0x018d6b60 (IDX = 0).
The data ring starts at 0x018f4d60.
TpTxMblkDR = 0x0104055c, TxDRIdx = 1, TxDRCleanIdx = 1
(-2) next 0xa04d8f21, flag1 0x00000000, flag2 0x00000000, buffer 0x00000000
(-1) next 0xc04d8f21, flag1 0x00000000, flag2 0x00000000, buffer 0x00000000
( 0) next 0xe04d8f21, flag1 0x00000000, flag2 0x00000000, buffer 0x00000000
( 1) next 0x004e8f21, flag1 0x00000000, flag2 0x00000000, buffer 0x00000000
( 2) next 0x204e8f21, flag1 0x00000000, flag2 0x00000000, buffer 0x00000000
[...]
RX RING ENTRIES:
The interrupt ring starts at 0x018d6ac0 (IDX = 0).
The data ring starts at 0x018f3540.
RxDRNum = 64, pRxMblkDR = 0x018f6b8c, RxDRIdx = 0
RxBuffSize = 1728, RxBuffOffset = 160
(-2) next 0x60358f21, flag1 0x0000fc05, flag2 0x00000000, buffer 0xe07d5021
(-1) next 0x80358f21, flag1 0x0000fc05, flag2 0x00000000, buffer 0xa0845021
( 0) next 0xa0358f21, flag1 0x0000fc05, flag2 0x00000000, buffer 0x608b5021
( 1) next 0xc0358f21, flag1 0x0000fc05, flag2 0x00000000, buffer 0x20925021
( 2) next 0xe0358f21, flag1 0x0000fc05, flag2 0x00000000, buffer 0xe0985021
[...]
show interface bri
This command displays ISDN Basic Rate Interface (BRI) information for an interface.
Syntax
show interface bri [card/port:channel.sub-interface]
card ISDN BRI card number, either 1 or 2.
port ISDN BRI port number, either 0 or 1.