Enterasys Networks X-Pedition XSR CLI - Manual (Page 337)

PIM Commands
XSR CLI Reference Guide 7-89
PIM Commands
ip pim sparse-mode
This command enables Protocol Independent Multicast (PIM) Sparse Mode (SM) on a local
interface.
Syntax
ip pim sparse-mode
Syntax of the “no” Form
The no form of this command disables PIM on an interface:
no ip pim sparse-mod
Mode
Interface configuration: XSR(config-if<xx>)#
Default
PIM‐SM is disabled on an interface
Example
The following example enables PIM sparse mode on F1:
XSR(config-if<F1>)#ip pim sparse-mode
ip pim bsr-border
This command specifies an interface so BootStrap Router (BSR) messages are not sent or received
through an interface.
Syntax
ip pim bsr-border
Syntax of the “no” Form
The no form of this command removes the BSR border setting:
no ip pim bsr-border
Mode
Interface configuration: XSR(config-if<xx>)#