Enterasys Networks X-Pedition XSR CLI - Manual (Page 382)

Multilink PPP Commands
8-112 Configuring the Point-to-Point Protocol
Syntax
ppp bap number {default phone-number}
Syntax of the “no” Form
The no command removes a BAP phone number:
no ppp bap number {default phone-number}
Mode
Dialer Interface configuration: XSR(config-if<Dx>)#
Example
The following example specifies the BAP default phone number:
XSR(config)#interface dialer 1
XSR(config-if<D1>)#ppp bap number
ppp bap timeout
This command configures Bandwidth Allocation Protocol (BAP) action timeouts to set up
Bandwidth‐on‐Demand (BoD).
The multilink load-threshold command is a second means by which the XSR controls traffic
via BoD. It is also provided by setting the multilink min-links command.
Syntax
ppp bap timeout {pending seconds | response seconds}
Syntax of the “no” Form
The no command deletes BAP action timeouts:
no ppp bap timeout {pending | response}
Defaults
• Pending seconds: 20
• Response seconds: 20
Mode
Dialer Interface configuration: XSR(config-if<Dx>)#
default phone-number Primary number for incoming calls. Up to 5 numbers can be entered.
pending seconds Wait interval for pending actions. Range: 2 to 180 seconds.
response seconds Wait interval for response packets. Range: 2 to 180 seconds.