Enterasys Networks X-Pedition XSR CLI - Manual (Page 417)

Frame Relay Commands
XSR CLI Reference Guide 9-93
frame-relay lmi-type
This command configures the Local Management Interface (LMI) type on a per‐interface basis.
Syntax
frame-relay lmi-type {ilmi | ansi | q933a | auto | none}
Syntax of the “no” Form
Use the no command to return to the default LMI type:
no frame-relay lmi-type {ilmi | ansi | q933a | auto | none}
Default
auto
Mode
Interface configuration: XSR(config-if<xx>)#
Example
This example sets serial interface 1/0 to use the ANSI Annex‐D LMI:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay lmi-type ansi
XSR(config-if<S1/0>)#no shutdown
frame-relay traffic-shaping
This command enables map‐class parameters for all Permanent Virtual Circuits (PVCs) on a
Frame Relay port. For virtual circuits which have no specific traffic shaping or queuing
parameters specified, a set of default values is used.
Syntax
frame-relay traffic-shaping
ilmi Interim LMI (FRF 1.1).
ansi Annex D defined by American National Standards Institute (ANSI) standard
T1.617.
q933a ITU‐T Q.933 Annex A.
auto The port will attempt to detect and match the LMI type used by the attached Frame
Relay switch.
none No LMI used. This is meant to test or connect XSRs directly.