Enterasys Networks X-Pedition XSR CLI - Manual (Page 467)

ISDN Commands
Book Title goes here 11-89
Syntax
isdn switch-type switch-type {basic-dms100 | basic-ni1 | basic-ntt | basic-net3 |
primary-net5 | primary-ni2 | primary-5ess | primary-dms100 | primary-ntt}
BRI Switch Types:
PRI Switch Types:
Syntax of the “no” Form
The no form of this command deletes the three serial interfaces:
no isdn switch-type
Defaults
• BRI: basic‐net3
• PRI: primary‐net5
• E1: primary‐net5
• T1: primary‐ni2
• J1: primary‐ntt
Mode
BRI/PRI Interface configuration: XSR(config-if<BRI/PRI-xx>)#
Note: This command is valid only after the pri-group command was issued.
basic-dms100 North America legacy ISDN switch.
basic-ni1 National ISDN 1 switch for North America.
basic-5ess North America legacy ISDN switch: not supported.
basic-ntt Switch for ISDN in Japan.
basic-net3 ETSI‐compliant switch for Euro‐ISDN.
primary-net5 ETSI‐compliant switch for Euro‐ISDN.
primary-ni2 T1 National ISDN switch type (T1 default).
primary-5ess T1 NOAM legacy switch.
primary-dms100 T1 NOAM legacy switch.
primary-ntt T1/J1 ISDN switch for Japan.