Enterasys Networks X-Pedition XSR CLI - Manual (Page 214)

RTP Header Compression Commands
5-138 Configuring the Internet Protocol
UDP payload must be less than 500 bytes
Packet must not be fragmented
The destination port of the packet must be within user configured port range (there is no
restriction on the source port)
Note: The XSR doesn’t impose any restrictions on RTP de‐compression.
clear ip rtp header compression interface serial
This command clears the RTP header compression statistics for the specific PPP serial interface.
Syntax
show ip rtp header-compression interface serial slot/port{.sub-interface}
Mode
Privileged EXEC: XSR
Example
The following example clears the RTP Statistics for serial interface 2/0:1
XSR# clear ip rtp header‐compression interface serial 2/0:1
ip rtp compression connections
By default, the software supports a total of 16 RTP header compression connections on the PPP
interface. This command will allow the user to change the number of RTP header compression
connections in order to specify the total number of RTP header compression connections
supported on an interface.
If either end of the PPP link have different max‐num‐connection values, than the link will
negotiate to the lower value.
Syntax
ip rtp compression connections max-num-connections
Syntax of the “no” Form
The no command resets the RTP header compression connections to the default value of 16:
no rtp compression connections
Default
16 RTP header compression connections on the PPP interface
slot/port{.sub-interface The slot, port and sub‐interface this command is to be applied
to.
max-num-connections The max number of RTP connections to be supported on the PPP
interface. Range: 3 ‐ 1000