Enterasys Networks X-Pedition XSR CLI - Manual (Page 159)

XSR CLI Reference Guide 5-83
5
Configuring the Internet Protocol
Observing Syntax and Conventions
The CLI Syntax and conventions use the notation described below.
IP Commands
The following command sets define IP functionality on the XSR including:
• “OSPF Commands” on page 5‐84.
• “OSPF Debug and Show Commands” on page 5‐104.
• “RIP Commands” on page 5‐123.
• “RIP Show Commands” on page 5‐136.
• “RTP Header Compression Commands” on page 5‐137.
• “Policy‐Based Routing Commands” on page 5‐145.
• “PBR Clear and Show Commands” on page 5‐148.
• “ARP Commands” on page 5‐149.
• “Other IP Commands” on page 5‐151.
• “IP Clear and Show Commands” on page 5‐168.
• “Network Address Translation Commands” on page 5‐182.
• “Virtual Router Redundancy Protocol Commands” on page 5‐191.
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars
indicates a required choice of an optional parameter
(config-if<xx>) xx signifies interface type and number, e.g.: F1 , S2/1.0 , D1 , M57 , G3.
F indicates a FastEthernet, and G a GigabitEthernet interface.
Next Mode entries display the CLI prompt after a command is entered.
Sub‐command headings are displayed in red text.
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis