Enterasys Networks X-Pedition XSR CLI - Manual (Page 156)

Hardware Controller Clear and Show Commands
4-104 Configuring Hardware Controllers
XSR#show interface multilink 8
********** Multilink Interface Stats **********
Multilink 8 is Admin Down
Internet address is not assigned
LCP State: CLOSED
Multilink State: CLOSED
Max Fragment delay is 10 ms
MLPPP Bundle Info:
Control Object state is Admin Down / Oper Down
Multilink PPP has no memberlinks
Data Object state is Admin Down
The adjacent is DOWN and data passing is FALSE
Bundle size is 0
Max Load Threshold: 0
Total Load Bandwidth is 64000 bits/sec
Bundle Stats
Rx: Total 0, TX: Total 0
Data 0, Data 0
Ctrl 0, Ctrl 0
Null 0, Null 0
Drop 0, Drop 0
Rx Load BW Avg 0, Max 0, Min 0
Tx Load BW Avg 0, Max 0, Min 0
show interface null
This command displays attributes of the null interface (Null 0), an IP interface which uniquely
does not require an IP address to appear. It is installed automatically by the XSR so that discard
routes can be employed by OSPF. You cannot configure this interface, it is always
administratively up and cannot be deleted.
The Null interface displays only when you enter show ip interface null 0 or show
interface null 0 . If it is not specified in the show interface or show ip interface
commands, it will not display. Also, it does not display in the running‐config file.
Syntax
show interface null 0
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Sample Output
The following example is sample output from the show ip interface null 0 command:
XSR#show ip interface null 0
Null0 is Admin Up
Internet address is not assigned
Rcvd:
0 octets, 0 unicast packets,
0 discards, 0 errors, 0 unknown protocol.