Enterasys Networks X-Pedition XSR CLI - Manual (Page 524)

Other ADSL Commands
13-98 Configuring ADSL
no shutdown
This command sets the ATM interface to the administrative Up state and enables the line for
operation. Data traffic cannot flow until at least one associated sub‐interface is set to the
administrative Up state. Issuing this command does not change the administrative state of sub‐
interfaces associated with this ATM interface.
This command surveys the status of the DSP firmware (which was loaded and started at boot
time) and if it finds it in an illegal state (i.e., crashed), it reloads and restarts the DSP firmware
before proceeding with the
no shutdown operation. Depending on the size of the DSP firmware
and characteristics of the download process, this operation may take a noticeable length of time.
Syntax
no shutdown
Mode
ATM Interface configuration: XSR(config-if<ATMxx>)#
Example
The following example sets the ATM interface to the administrative up state:
XSR(config-if<ATM0/1/0>)#no shutdown
shutdown
This command sets the ATM interface to the administrative Down state. As a result, all ATM sub‐
interfaces associated with this ATM interface are shut down, all data traffic is stopped and the line
disabled.
Syntax
shutdown
Syntax of the “no” Form
Refer to no shutdown on page 13‐98 .
Mode
ATM Interface configuration: XSR(config-if<ATMxx>)#
Example
The following example sets the ATM interface to the administrative down state:
XSR(config-if<ATM0/1/0>)#shutdown