Enterasys Networks X-Pedition XSR CLI - Manual (Page 575)

Interface CLI Commands
XSR CLI Reference Guide 14-121
Interface CLI Commands
crypto map
This command applies a previously defined crypto map to an interface. It is governed by the
following rules:
• A crypto map must be assigned to an interface before that port can provide IPSec services.
• Only 1 crypto map can be assigned an interface although it can be attached to multiple ports.
• A crypto map may not be assigned to an interface that already has crypto ezipsec enabled.
• Crypto maps may not be assigned to a VPN interface ( it is invalid at Interface VPN mode).
Syntax
crypto map map-name
Syntax of the “no” Form
Delete a crypto map from the interface with the no form of this command:
no crypto map [map-name]
Mode
Interface configuration: XSR(config-if<xx>)#
Next Mode
Crypto Map configuration: XSR(config-crypto-m)#
Sample Output
This example assigns crypto map ACMEmap to the F1 interface. When traffic passes through F1, it
will be evaluated against all the crypto map entries in the ACMEmap set. When outbound traffic
matches an access list in one of the ACMEmap crypto map entries, a Security Association will be
established for that crypto map entryʹs configuration (if no SA or connection already exists).
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#crypto map ACMEmap
map-name Crypto map ID assigned when the crypto map was created.