Crypto transform mode commands, Crypto transform mode commands -115 – Enterasys Networks X-Pedition XSR CLI User Manual
Page 569
Crypto Transform Mode Commands
XSR CLI Reference Guide 14-115
Example
This example defines two transform‐sets, specifying both can be used within a crypto map entry.
When traffic matches ACL 101, the SA can use either transform‐set my_t_set1 (first priority) or
my_t_set2 (second priority) depending on which transform‐set matches the remote peerʹs
transform‐sets.
XSR(config)#crypto ipsec transform-set my_t_set1 esp-des esp-sha-hmac
XSR(config)#crypto ipsec transform-set my_t_set2 ah-sha-hmac esp-des esp-sha-hmac
XSR(config)#crypto map ACMEmap 7 ipsec-isakmp
XSR(config-crypto-m)#match address 101
XSR(config-crypto-m)#set transform-set my_t_set1 my_t_set2
XSR(config-crypto-m)#set peer 10.0.0.1
Crypto Transform Mode Commands
crypto ipsec transform-set
This command defines a transform‐set which is an acceptable combination of security protocols
and algorithms to apply to IP Security protected traffic. During IPSec Security Association (SA)
negotiation, peers agree to use a particular transform‐set when protecting a particular data flow.
This command acquires Crypto Transform configuration Mode. The following sub‐commands are
available in this mode:
•
set pfs
‐ Specifies that IPSec should ask for PFS when seeking new SAs for this crypto map
entry, or that IPSec requires PFS when getting requests for new SAs. Refer to
for
the command definition.
•
set security-association lifetime
‐ Specifies the interval used when negotiating IPSec
A transform‐set is an acceptable combination of security protocols, algorithms and other settings
to apply to IP Security‐protected traffic. During IPSec SA negotiation, the peers agree to use a
particular transform‐set when protecting a particular data flow.
Syntax
crypto ipsec transform-set transform-set-name transform1 [transform2 [transform3]]
transform-
set-name
Name of the transform‐set to create or modify.
transform1
Specify up to 3 transforms defining the IPSec security protocols and
algorithms. The choices are:
•
ah‐md5‐hmac: AH transform with HMAC‐MD5 algorithm.
•
ah‐sha‐hmac: AH transform with HMAC‐SHA algorithm.
•
esp‐3des: ESP transform with 56‐bit DES encryption (168‐bits).
•
esp‐aes: ESP transform with 128‐bit AES encryption.
•
esp‐des: ESP transform with 168‐bit Triple DES encryption.
•
esp‐md5‐hmac: ESP transform with HMAC‐MD5 data integrity algorithm.
•
esp‐null: ESP transform with no encryption.
•
esp‐sha‐hmac: ESP transform with HMAC‐SHA data integrity algorithm.