Enterasys Networks X-Pedition XSR CLI - Manual (Page 450)

DOD/BOD Commands
10-96 Configuring the Dialer Interface
show interface dialer
This command displays general information for a dialer interface.
Syntax
show interface dialer number
Mode
Privileged EXEC: XSR#
Sample Output
The example below displays output from the show interface dialer command:
XSR#show interface dialer
********** Dialer Interface Stats **********
Dialer1 is Admin Up
Internet address is 10.10.10.1, subnet mask is 255.255.255.0
Dialer1
Dialer state is: UP
Wait for carrier default: 60, default retry: 3
Dial String
Success Failures Map Class
Dialer pool 3
(Serial 2/0:0, )
Free pool ISDN channels: <25>
Free pool serial ports: <0>
Neighbor Dial String Success Failures Map Class
3100 1 0
Active links MLPPP group <1> to <10.10.10.2>: <5>
DOD/BOD Commands
The XSR supports the following Dial on Demand (DoD)/Bandwidth on Demand (BoD)
commands.
dialer-group
This command controls dialer access by configuring an interface to belong to a specific dialing
group. This access group is associated with an access list by the
dialer-list command.
Packets which match the dialer group trigger a connection request. That is, the destination address
of packets is evaluated against one or more ACLs; if the packets pass, either a call is initiated (if no
connection were already established) or the idle timer is reset (if a call is active).
number Dialer interface number ranging from 0 to 255