Enterasys Networks X-Pedition XSR CLI - Manual (Page 523)

Other ADSL Commands
XSR CLI Reference Guide 13-97
Syntax
pvc vpi/vci
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no pvc
Mode
ATM Sub‐Interface configuration: XSR(config-if<ATMx/x/x.x>)#
Default
VPI/VCI defaults to 1/32. This is not the ILMI virtual circuit.
Example
This example sets the sub‐interface circuit type to PVC and sets the ATM VPI/VCI values to 2/48:
XSR(config-if<ATM0/1/0.1>)#pvc 2/48
shutdown
This command sets the ATM sub‐interface to the administrative Down state halting all data traffic
on this VC.
Syntax
shutdown
Syntax of the “no” Form
Refer to the atm sub-interface command on page 13‐88 .
Mode
ATM Sub‐Interface configuration: XSR(config-if<ATMx/x/x.x>)#
Example
The following example sets the ATM sub‐interface to the administrative down state:
XSR(config-if<ATM0/1/0.1>)#shutdown
vpi/vci ATM VC identifier values. VPI range: 0 to 255, VCI range: 0 to 65535.