Enterasys Networks X-Pedition XSR CLI - Manual (Page 528)

PPP Configuration Commands
13-102 Configuring ADSL
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no ppp pap
Mode
ATM Sub‐Interface configuration: XSR(config-if<ATMx/x/x.x>)#
Default
PAP is disabled
Example
The following example sets the PAP user name to bob and the password to confidential:
XSR(config-if<ATM0/1/0.1>)#ppp sent-name bob password confidential
ppp quality
This command configures the minimum link quality for PPP, which is a measure of the amount of
data successfully passed over the link. The minimum quality value is specified as a percentage of
the total data sent. This command requires a properly configured ATM sub‐interface specifying
encapsulation type PPPoA or PPPoE.
Syntax
ppp quality <percent>
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no ppp quality
Mode
ATM Sub‐Interface configuration: XSR(config-if<ATMx/x/x.x>)#
Default
Disabled
Example
The following example sets the minimum link quality value to 88%:
XSR(config-if<ATM0/1/0.1>)#ppp quality 88
percent The minimum link quality value, ranging from 0 to 100.