Enterasys Networks X-Pedition XSR CLI - Manual (Page 61)

XSR CLI Reference Guide 2-55
2
Configuring T1/E1 and T3/E3 Subsystems
Observing Syntax and Conventions
The CLI Syntax and conventions use the notation described in the following table.
T1/E1 & T3/E3 Commands
The following commands define T1/E1 /T3/E3 subsystem functionality:
• “T1/E1 & T3/E3 Commands” on page 2‐55.
• “T1/E1 and T3/E3 Clear and Show Commands” on page 2‐74.
• “Drop and Insert Commands” on page 2‐80.
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
(config-if<xx>) xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, G3. F
indicates a FastEthernet, and G a GigabitEthernet interface
Next Mode entries display the CLI prompt after a command is entered
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text
with special emphasis
Note: The configuration commands for T1/E1 ports that occupy T3/E3 lines are the same
commands that exist for T1/E1 NIM cards.