Enterasys Networks X-Pedition XSR CLI - Manual (Page 331)

XSR CLI Reference Guide 7-83
7
Configuring IP Multicast
Observing Syntax and Conventions
The CLI command syntax and conventions use the notation described below.
IGMP and Generic Multicast Commands
The following command sets define IP Multicast functionality on the XSR, including:
• “PIM Commands” on page 7‐89.
• “IGMP Clear and Show Commands” on page 7‐95.
ip multicast-routing
This command enables/disables multicast routing and multicast switching.
Syntax
ip multicast-routing
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
(config-if<xx>) xx signifies the interface, class map, policy map or other value you specify;
e.g., F1, G3, S2/1.0, <Your Name>. F indicates a FastEthernet, and G a
GigabitEthernet interface.
Next Mode entries display the CLI prompt after a command is entered.
Sub-commands are displayed in red text.
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis