Enterasys Networks X-Pedition XSR CLI - Manual (Page 411)

Frame Relay Commands
XSR CLI Reference Guide 9-87
Next Mode
Frame Relay DLCI configuration: XSR(config-fr-dlci<xx>)#
Examples
The following example maps DLCIs 16 and 18 on serial sub‐interface 1/0.1 to the specified IP
addresses, supporting bootp and sending a free inverse ARP. Also, DLCI 17 is configured on sub‐
interface 1/0.2, a free inverse ARP is sent, and emote keep‐alive is supported in P2P mode.
XSR(config)#interface serial 1/0.1 multi-point
XSR(config-subif)#ip helper 10.10.1.2
XSR(config-subif)#ip address 133.133.1.1 255.255.255.0
XSR(config-subif)#frame-relay interface-dlci 16 ip 133.133.1.2 gratuitous-
inverse-arp bootp
XSR(config-fr-dlci)#frame-relay interface-dlci 18 ip 133.133.1.3 bootp
XSR(config-fr-dlci)#no shutdown
XSR(config-fr-dlci)#interface serial 1/0.2 point-to-point
XSR(config-subif)#ip helper 10.10.1.2
XSR(config-subif)#ip address 133.134.1.1 255.255.255.0
XSR(config-subif)#frame-relay interface-dlci 17 gratuitous-inverse-arp keep-alive
30
XSR(config-fr-dlci)#no shutdown
frame-relay intf-type
This command defines the Frame Relay interface type for the interface. The XSR works as a UNI
device only, with DTE or DCE as valid entries.
Syntax
frame-relay intf-type {dte | dce}
Syntax of the “no” Form
no frame-relay intf-type {dte | dce}
Mode
Interface configuration: XSR(config-if<xx>)#
Default
dte
Examples
The following example configures Serial interface 1/0 to act as a Frame Relay DTE, and to use the
ANSI Annex‐D LMI:
dte Specifies the XSR to act as a Frame Relay DTE UNI device.
dce Specifies the XSR to act as a Frame Relay DCE UNI device.