Enterasys Networks X-Pedition XSR CLI - Manual (Page 485)

Policy-Map Commands
XSR CLI Reference Guide 12-89
police
This command configures traffic policing.
Syntax
police bps [burst-normal][burst-max][conform-action action][exceed-action
action][violate-action action]
Syntax of the “no” Form
Traffic policing is removed by using the no form of this command:
no police
Defaults
• burst‐normal: average rate multiplied by one second)
• conform‐action: transmit
• exceed‐action: drop
• violate‐action: drop
• Command is disabled by default
Mode
Policy‐Map Class configuration: XSR(config-pmap-c-<xx>)#
bps Average rate ranging from 1,000 to 100,000,000 bps.
burst-normal Normal burst size ranging from 1,000 to 51,200,000 bps. If less than 1000
bytes burst‐normal will be set to 1000 bytes.
burst-max Excess burst size ranging from 1,000 to 51,2000,000 bytes. Value must be
greater than or equal to normal‐burst size. It will automatically be changed to
the normal‐burst size if less than normal‐burst.
conform-action Action to take on packets that conform to the rate limit.
exceed-action Action to take on packets that exceed the rate limit.
violate-action Action to take on packets that violate normal and maximum burst sizes. If
violate‐action is set, the token bucket algorithm will use two token buckets.
action Action to take on packets. You may specify one keyword:
• drop ‐ Drops the packet.
• set-prec-transmit new-prec ‐ Sets IP precedence and sends the
packet.
• set-dscp-transmit new-prec ‐ Sets the differentiated services code
point (DSCP) value and sends the packet.
• transmit ‐ Sends the packet.