Enterasys Networks X-Pedition XSR CLI - Manual (Page 353)

XSR CLI Reference Guide 8-83
8
Configuring the Point-to-Point Protocol
Observing Syntax and Conventions
The CLI Syntax and conventions use the notation described in the following table.
PPP Commands
This chapter defines Point‐to‐Point Protocol (PPP) service profiles, specify and monitor serial
ports, and define Multilink PPP and Bandwidth Allocation Protocol (BAP) functionality in the
following command sets:
• “PPP Debug, Clear and Show Commands” on page 8‐97.
• “Multilink PPP Commands” on page 8‐108.
• “Multilink Show Commands” on page 8‐122.
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates a
required choice of an optional parameter
(config-if<xx>) xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, G3. F
indicates a FastEthernet, and G a GigabitEthernet interface.
Next Mode entries display the CLI prompt after a command is entered.
Sub-command headings are displayed in red text.
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis