Enterasys Networks X-Pedition XSR CLI - Manual (Page 343)

IGMP Clear and Show Commands
XSR CLI Reference Guide 7-95
Default
The threshold is 0
Example
The following example sets the source tree switching threshold to 4 kbps:
XSR(config)#ip pim spt-threshold 4
IGMP Clear and Show Commands
clear ip mroute
This command deletes entries from the multicast table.
Syntax
clear ip mroute [group-address][source-address]
Mode
EXEC configuration: XSR>
show ip igmp groups
This command displays the multicast groups with receivers that are directly connected to the XSR
and were learned through the Internet Group Management Protocol (IGMP).
Syntax
show ip igmp groups [group-address | type number | summary]
Mode
EXEC configuration: XSR>
Example
The following example displays sample responses:
XSR>show ip igmp groups
Interface name:
FastEthernet1
group-address IP address of the multicast group.
source-address IP address of the multicast source.
group-address Address of the multicast group.
type Interface type.
number Interface number.
summary A one‐line, abbreviated summary of each entry in the IGMP groups table.