Enterasys Networks X-Pedition XSR CLI - Manual (Page 558)

Remote Peer Show Commands
14-104 Configuring the VPN
Remote Peer Show Commands
show crypto isakmp peer
This command displays attributes for each ISAKMP peer. IKEʹs first configuration derives from
the IP address of the remote peer. ISAKMP peers created by EZ‐IPSec configuration are marked
with an asterisk (*) in the leftmost column of the
show output. These proposals may not be used in
other user‐defined ISAKMP policies ‐ they are reserved for EZ‐IPSec.
Syntax
show crypto isakmp peer
Mode
EXEC or Global configuration: XSR> or XSR(config)#
Sample Output
The following is sample output from the command:
XSR#show crypto isakmp peer
Applicable Subnet
Exch-Mode Config-Mode NAT User ID Proposals
192.168.57.4/2 Main Client Off p1 *** NONE ***
192.168.57.9/32 Main Disabled Off *** NONE ***
The following output was produced by an ISAKMP peer created by EZ‐IPSec:
XSR#show crypto isakmp peer
Applicable Subnet
Exch-Mode Config-Mode NAT User ID Proposals
* 141.154.196.87/32 Main Client Auto ez-ike-3des-sha-rsa
ez-ike-3des-md5-rsa
Parameter Description
Applicable subnet Subnet describing a range of IP addresses representing peers.
Applicable subnet Main or Aggressive.
Config‐Mode Client, Gateway or Disabled.
NAT Indicates whether NAT Traversal is On or Off. Be aware that Off may be
indicated even when NAT‐T is being used.
User ID User‐specified peer name.
Proposals IKE policies.