Enterasys Networks X-Pedition XSR CLI - Manual (Page 479)

XSR CLI Reference Guide 12-83
12
Configuring Quality of Service
Observing Syntax and Conventions
The CLI Syntax and conventions use the notation described in the following table.
QoS Commands
The following set of commands configure Quality of Service (QoS) values for the XSR:
• “Policy‐Map Commands” on page 12‐84.
• “Class‐map Commands” on page 12‐101.
• “QoS Show Commands” on page 12‐105.
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z}] [{ | } ] Combination of square brackets with braces and vertical bars
indicates a required choice of an optional parameter
(config-if<xx>) xx signifies the interface, class map, policy map or other value you
specify; e.g.,
F1 , G3 , S2/1.0 , <Your Name> . F indicates a FastEthernet,
and G a GigabitEthernet interface.
Next Mode entries display the CLI prompt after a command is entered.
Sub‐command headings are displayed in red text.
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis