Nortel Networks 1000E - Manual (Page 115)

Installing and connecting CS 1000E hardware Page 115 of 466
Communication Server 1000E Installation and Commissioning
Connecting a Media Card to the TLAN subnet
Follow Procedure 16 to connect a Media Card to the TLAN subnet.
Procedure 16
Connecting a Media Card to the TLAN subnet
1 Connect a standard CAT5 patch cable to the TLAN network interface on
the adaptor (see Figure 29 on
page 114 ).
2 Connect the other end of the standard CAT5 patch cable to an RJ-45
TLAN network interface on the BayStack 470 switch.
End of Procedure
Connecting a Media Gateway to a Media Gateway
Expansion
Procedure 17 describes how to connect a Media Gateway Expander to the
Media Gateway. The Media Gateway Expander Cable Kit (NTDK89)
contains two NTDK95 cables used to connect the Media Gateway Expander
to the Media Gateway. One cable provides DS-30X connectivity while the
second cable provides CE-MUX connectivity to slot 10 only.
Procedure 17
Connecting a Media Gateway to a Media Gateway Expansion
1 Connect the non-labeled side of NTDK95 cable to the CE-MUX connector
at the back of the Media Gateway and labeled side of NTDK95(labeled as
Expansion Cabinet DS-30/CE-MUX Conn) to the CE-MUX connector at
the back of the Media Gateway Expander.
2 Tighten the screws on the connectors.
3 Connect the other NTDK95 cable (non-labeled side) to the DS-30X
connector at the back of the Media Gateway and labeled side of
NTDK95(labeled as Expansion Cabinet DS-30/CE-MUX Conn) to the
DS-30X connector at the back of the Media Gateway Expander.
4 Tighten the screws on the connectors. Figure 30 on page 116 shows the
Media Gateway and Media Gateway Expander connected with the two
NTDK95 cables.