Nortel Networks 1000E - Manual (Page 327)

Installing and configuring a Voice Gateway Media Card Page 327 of 466
Communication Server 1000E Installation and Commissioning
4 Exit from LD 14. Enter the command:
****
End of Procedure
Saving configuration changes
Perform a datadump to save configuration changes. Complete the steps in
Procedure 88: "Performing a datadump using Element Manager" on
page 376 .
MAXU 32
24
32 is the maximum number of voice Media Gateway channels on
the Media Card.
24 is the maximum number of voice Media Gateway channels on
the ITG-P Line card.
IPTN YES ITG Physical TN.
ZONE 0-255 Zone number to which the Voice Gateway Media Card Physical
TNs belong.
Verify that the zone exists in LD 117.
The ZONE prompt is not available when configuring VGW in an
MG 1000E. The VGWs are assigned the same zone as the
MG 1000E.
Note: If the Zone of an MG 1000E is changed, all VGW in the
MG 1000E must be removed and reconfigured to assume the
new Zone of the MG 1000E.
CUST xx The customer to which the IPTN resources are assigned.
Note: This means that for multi-customer CS 1000E systems,
each customer must have a dedicated IP Telephony node for
IP Phones.
Table 43
LD 14 – Configure physical TNs (Part 2 of 2)
Prompt Response Description