Nortel Networks 1000E - Manual (Page 146)

Page 146 of 466 Installing software on the CS 1000E
NN43041-310 Standard 01.11 October 2008
2 Enter port and security parameters, if required:
Change MGC advanced parameters? (y/[n]) : y
TLAN is set to auto negotiate, change? (y/[n]) : y
Note: Turning off auto negotiate on the TLAN
: will default it to 100Mbps full duplex.
Set TLAN to auto negotiate? ([y]/n) : y
ELAN is set to auto negotiate, change? (y/[n]) : y
Note: Turning off auto negotiate on the ELAN
: will default it to 100Mbps full duplex.
Set ELAN to auto negotiate? ([y]/n) : y
ELAN security Disabled, change? (y/[n]) : y
Enable ELAN security ? (y/[n]) : y
Enter security level OPTI, FUNC or FULL : opti
Note: Spaces ~ * ` @ [ ] and # are not supported in
passwords.
Please input PSK(16-32 chars): (input is not echoed)
Strength of PSK: Weak
Please reenter PSK(16-32 chars): (input is not echoed)
3 Review the network information and enter “y” to confirm.
You have entered the following parameters for this MG
1000E:
Hostname : MGC_N313
ELAN IP : 192.168.3.33
ELAN subnet mask : 255.255.255.0
ELAN gateway IP : 192.168.3.1
TLAN IP : 192.168.19.33
TLAN subnet mask : 255.255.255.0
TLAN gateway IP : 192.168.19.1
Primary CS Hostname : CS1000E_N313
Primary CS IP : 192.168.3.32
Alternate CS 1 Hostname :
Alternate CS 1 IP : 0.0.0.0
Alternate CS 2 Hostname :
Alternate CS 2 IP : 0.0.0.0