Nortel Networks 1000E - Manual (Page 434)

Page 434 of 466 Installing and configuring Nortel IP Phones
NN43041-310 Standard 01.11 October 2008
installed, you can still choose it as the audio device from the Configuration
Utility.
Procedure 103
Installing the USB Headset Kit
1 Connect the coiled lower cord to the headset cord with the Quick
Disconnect connector. Ensure the Quick Disconnect is securely fastened.
2 Connect the headset cord to the RJ9 jack on the adaptor.
3 Connect the USB cable to the headset adaptor and to one of the USB
jacks at the back of your PC or USB hub.
End of Procedure
The first time the headset adapter is plugged in, there is a delay while
Windows
® configures the device and locates appropriate driver software.
During the installation you can be prompted to supply the original Windows
CD-ROM so that Windows can locate the required drivers.
Installing the IP Softphone 2050 application
Procedure 104
Installing the IP Softphone 2050 on your PC
1 Insert the CD-ROM disk into the CD-ROM drive of your PC.
Note: Installation should proceed automatically. If it does not, then
continue with step 1. Otherwise go directly to step 5.
2 On the PC desktop, double-click the My Computer icon.
3 Double-click the CD icon.
4 Double-click the Setup icon.
5 Follow the prompts that appear on the screen.
6 Run the IP Softphone 2050 Configuration Utility to assign a server
address, select sound devices, and select a server type.
End of Procedure